2020 Ford Explorer Transmission Problems

The transmission park pawl may engage while the vehicle is in motion, resulting in park system damage. Park system damage may result in a vehicle rollaway, increasing the risk of a crash.

Fix: Dealers will update the powertrain control module software, and inspect and replace any damaged transmission components as necessary, free of charge.

The rear axle horizontal mounting bolt may fracture and cause the driveshaft to disconnect. A disconnected driveshaft can result in vehicle rollaway when the vehicle is placed in park without the parking brake applied. A disconnected driveshaft can also result in a loss of drive power. Either of these scenarios can increase the risk of a crash.

Fix: Dealers will update the powertrain control module (PCM) software, free of charge.

The rear axle horizontal mounting bolt may fracture and cause the driveshaft to disconnect. A disconnected driveshaft can result in a loss of drive power or a vehicle rollaway if the parking brake is not applied. Either of these scenarios can increase the risk of a crash.

Fix: Dealers will replace the subframe bushing and rear axle bolt. They will also inspect the rear axle cover for damage near the bolt hole location and replace with a new cover if any damage is found.

3L RWD, 3.3L GAS, 3.3L FHEV, or 3.0L ST powertrain. The previous powertrain control module (PCM) update completed under recall 22V-255 did not include the automatic electronic parking brake feature when the vehicle is shifted to park, as intended. In addition, the rear axle horizontal mounting bolt may fracture and cause the driveshaft to disconnect. Without the electronic parking brake applied, the vehicle could rollaway if the driveshaft disconnects. A disconnected driveshaft can also result in a loss of drive power. Either of these scenarios can increase the risk of a crash.

Fix: Dealers will update the PCM software, free of charge.

3L engine and 10R60 automatic transmission. An unintentional powertrain control module (PCM) reset may occur while the vehicle is in motion and result in park system damage. A park system that is damaged may not shift into "PARK," resulting in a vehicle rollaway and increasing the risk of injury or crash.

Fix: Dealers will inspect the park system for damage and repair as necessary, free of charge.

0L or 3.3L engine and a 10 Speed Automatic Transmission with the All Wheel Drive package. The drive shaft may fracture along the weld seam. Defective drive shafts may fail and cause a loss of connection between the transfer case and rear axle, possibly resulting in a vehicle rollaway when in Park or a loss of drive. Either condition can increase the risk of a crash. The drive shafts can also deform and separate from the driveline and potentially contact the fuel tank, increasing the risk of fuel leaks and/or fire.

Fix: Ford will notify owners, and dealers will inspect the drive shaft label inspected and replace it as necessary, free of charge.

The Manual Park Release (MPR) cover may not be installed. In addition, the vehicles may be in Factory Mode, which disables warning alerts and does not display the transmission gear selected. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) numbers 114, "Theft Prevention" and 102, "Trans Shift Lever Seq/Starter Interlock/Trans Braking Effect." Without the cover, the MPR lever may be unintentionally moved, allowing the vehicle to roll away. Being in Factory Mode, the vehicle will not display warnings and/or gear selection on the instrument cluster. Both conditions increase the risk of a crash.

Fix: Ford will notify owners, and dealers will inspect and, if necessary, install a MPR cover. Dealers will verify the instrument cluster is not in Factory Mode and clear any fault codes, free of charge.